53-1004106-15 Installation Guide
Brocade
®
X6-4 Director Hardware Installation Guide
3. If applicable, lock the wheels of the lift.
4. Carefully lift the device and slide it into the rack.
5. Secure the device to the rack with six 10-32 screws with washers, three screws on each side (see the following figure).
Tighten the screws according to specifications under
NOTE
Screws, clip nuts, and retainer nuts for securing the device to the equipment rack are included in the device
hardware accessory kit.
Figure 9: Brocade Device with 18-24 in. (45.72 to 60.96 cm) Kit Installed in Rack
1. 10-32 x .63 in.(1.60 cm) Phillips screw with square cone washer for racks that have rails with round holes
NOTE
For rails with round holes, use the clip nuts on the front rails for securing 10-32 screws. For rails with square
holes, use the retainer nuts.
6. Reinstall the device door if removed.
See the procedures for removing and replacing the device door in this guide.
Installing the Device in a 27–31-Inch Rack (XBR-DCX4S-0121)
Use the following instructions to install the device in a rack with rail-to-rail depth of 27 to 31 in. (68.58 to 78.74 cm). Be
sure to use the 27–31 in. 8U Chassis Airflow Diversion and Port Side Exhaust Kit for Four-Post Rack (XBR-DCX4S-0121)
for this installation.
53-1004106-15
33
Summary of Contents for Brocade X6-4
Page 208: ......
