install - concepts - PixMaster - switcher - CG - clips - controls - team - appendix
Broadcast Pix
V8.5
6.
On the PixPad shown above, press the
[Set Cam Addr]
PixButton, which
will bring up a numeric keypad, as shown below left.
7.
Use the numeric keypad to enter the number you wish to assign to this
camera, either
1, 2, 3, 4, 5, 6, 7, 8
or
9.
The address you select will
appear in the large display. If it isn’t correct, press clear and press the
desired number.
8.
Press the
[Enter]
PixButton, and the PixPad shown in the upper right will
appear.
9.
Press the
[Change Address]
PixButton and the selected camera number
will be assigned to the head that is not unplugged. (If instead you want to
cancel at this point, press the [Cancel] PixButton.)
To verify it was programmed correctly, you can press Cam Select at the
bottom of the Pix pad and select the camera you just programmed. Move
the joy stick and the head of that camera should move. If the head does
move, you can unplug that camera and repeat the process with the
remaining cameras, to assign each a number.
7.7.3