install - concepts - PixMaster - switcher - CG - clips - controls - team - appendix
Broadcast Pix
V8.5
4.3.3
Changing Effect Transition Rates
The transition rate of any effect or mix may be changed by either turning the Rate
knob, or using the numeric keypad.
The transition rate is displayed on the lower right corner of the display. For
example, the illustration below shows a rate of 30 frames. Rates are displayed in
frames, with 30 frames being equal to one second in NTSC/525 and 25 being
equal to one second in PAL/625. The system defaults to 30 frames until another
rate is selected.
Since there are two M/Es with two transition controls, you may have different
transition rates for each M/E. The same steps apply for either M/E.
To change the transition rate with a knob:
1. If the Device Controls are not already assigned to effects, press the
[Effects]
PixButton
in the transition section and the display illustrated below will appear.
2.
Turn the
[Rate]
Knob (1
st
Knob)
to the desired rate.
The number of frames will be shown in the right corner of the display
TRate: 30
.
This rate will be now be used for all transitions until changed.
4.3.3