Bosch Rexroth Tightening System 350, Manual

Page: 363 / 641

3 608 878 300 Tightening Technology | Bosch Rexroth AG 363 /641
System 350 | 3 608 878 300/2019-03
MID 0041 revision 002-2, only Rexroth OP-Ford and Rexroth OP-BMW:
Cycles since check – ErgoSpin: Calculated from the cycles during the last check and the
current number of cycles
– Tightening spindle: cycles for the primary transducer
The value consists of ten ASCII characters.
ID 07
2
Value range 0000000000 – 9999999999
Presetting -
Example:
Cycles since check 123412
Value 0000123412
10
Tool type The value consists of two ASCII characters.
ID 08
2
Value range 00 – 99
Value – ErgoSpin: 04
– Tightening spindle: 11
2
Motor size – ErgoSpin: fixed value 01
– Tightening spindle: Motor size 02 – 05
The value consists of two ASCII characters.
ID 09
2
Value range 00 – 99
Presetting -
Example (tightening spindle):
Motor size 03
Value 03
2
Open end data The value consists of three ASCII characters.
ID 10
2
Fixed value 000
3
Software version Firmware version for SE/CS.
The value consists of 19 ASCII characters.
ID 11
2
Value range 0x20 – 0x7F
Presetting -
Example:
Software version CS V2.100 release
Value CS V2.100 release
19
Data length revision 002 (= data length revision 001 + data length revision 002)
136
Table 6–93: MID 0041 revision 002-2
Parameter Comments Bytes
This revision includes the information from revision 001 and the following additional information:
Software version1 Firmware version for SE/CS.
The value consists of 19 ASCII characters.
ID 05
2
Value range 0x20 – 0x7F
Presetting -
Example:
Software version CS V2.100 release
Value CS V2.100 release
19
Table 6–92: MID 0041 revision 002-1
Parameter Comments Bytes