44
en | Installing Roof Parapet and Pipe Mounts
AutoDome 600 Series Analog PTZ Camera
F.01U.215.782 | 1.0 | 2011.04
Installation Manual
Bosch Security Systems, Inc.
3.4.3
Wiring the Power Supply Box
1.
Route the high voltage 115/230 VAC lines through the conduit fitting on the left side of
the box.
2.
Cut and trim the high voltage 115/230 VAC power and ground wires with sufficient slack
to reach their connector terminal in the box, but not so long as to be pinched by or to
obstruct closing the Cover Door. Refer to
Section 3.1.1 Parts List, page 37
, for connector
location.
3.
Attach the supplied 3-pin Power Plug to the incoming high voltage power wires in the
box. Refer to connector P101 in
Table 3.1, Page 47
.
4.
If you are using UTP for video, route the UTP cable out to where the AutoDome will be
mounted. Refer to
Section 5 Cable and Wire Standards, page 70
for fiber optic
specifications.
5.
Route the low power 24 VAC wires from the right side of the Power Supply Box out to
where the AutoDome will be mounted. Attach the supplied 5-pin 24 VAC Dome plug to
the wire ends inside the box. Refer to connector P107 in
Table 3.1, Page 47
.
3.4.4
Wiring the Fiber Optic Model
1.
If installing a Fiber Optic model, bring the fiber optic cable into the right side of the
power supply box.
2.
If installing a Fiber Optic model attach the incoming ST fiber plug, installed previously, to
its mating connector on the Fiber Optic Module in the power supply box. Refer to
Section 5 Cable and Wire Standards, page 70
for fiber optic specifications.
NOTICE!
The Power Supply Box with transformer comes with a barrier that separates the high voltage
side on the left from the low voltage 24 VAC side on the right.
NOTICE!
All video, control, and alarm wires either pass through the Power Supply Box or by-pass it and
connect directly to the Pipe Interface Board.
NOTICE!
You will need a barrel connector (not supplied) to connect the BNC connector from the Pipe
Interface Board coax cable to the Fiber Optic Module BNC connector.
Summary of Contents for AutoDome 600 Series
Page 1: ...AutoDome 600 Series Analog PTZ Camera AutoDome 600 Series en Installation Manual ...
Page 2: ......
Page 90: ......
Page 91: ......
