Bosch AutoDome 600 Series, Installation Manual

Page: 61 / 92

AutoDome 600 Series Analog PTZ Camera Installing the In-Ceiling Mount | en 61
Bosch Security Systems, Inc. Installation Manual F.01U.215.782 | 1.0 | 2011.04
5. Tighten the four (4) securing screws to the Bracket Assembly.
Figure 4.4 Tighten Bracket Securing Screw
6. Secure the Bracket Assembly to an overhead securing point with a safety wire.
Figure 4.5 Secure Bracket Assembly
4.6 Wire the Interface Box
The Interface Box can be wired through the top or side. Use the supplied rubber plug to seal
the hole which will not be used to route wires.
CAUTION!
If you are using coaxial cable to connect an AutoDome to a head-end system, either through a
direct coaxial connection or through a fiber optic module, you must use the coax cable with
ferrite included in the AutoDome packaging. You must connect the incoming coax cable (from
the head-end) to the BNC jack (female connector) on the ferrite cable and connect the BNC
plug (male connector) of the ferrite cable to the BNC connector inside the Interface box. The
cable only connects to the AutoDome video output one way.