28
en | Installing the Pendant Arm Wall, Corner, and Mast (Pole) Mounts
AutoDome 600 Series Analog PTZ Camera
F.01U.215.782 | 1.0 | 2011.04
Installation Manual
Bosch Security Systems, Inc.
Figure 2.12
Optional Fiber Optic Module
9.
If using UTP for video, connect the incoming RJ45 video connector, installed previously,
to its mating connector from the Pendant Connector Harness. Refer to
Section 5 Cable
and Wire Standards, page 70
for connections and specifications.
10. Attach the grounding strap of the Pendant Arm to the Power Supply Box. Refer to
Figure 2.11
.
11. After making the harness connections to the Power Supply Box, rotate the Pendant Arm
to close and seal the Power Supply Box and tighten the two (2) captive screws to
10-12 N-m (90-105 in.-lbs).
12. Refer to
Section 2.10 Attach Pendant to Arm and Tighten, page 35
, to continue the VG5
AutoDome Installation procedure.
1
Transformer
6
ST Connector (Fiber)
2
BNC to Dome
7
Power In
3
In/Out
8
Data In/Out
4
From Arm Harness
9
Coax with Ferrite
5
In/Out
(GND)
GND TXD
RXD
C+
C-
(FUSE)
(FUSE)
(FUSE
)
24V NC 24V
HTR DOME
NOTICE!
After all wiring is complete, close the cover door and tighten the two (2) captive screws on
the cover door to 10-12 N-m (90-105 in.-lbs) to ensure the Power Supply Box is watertight.
Summary of Contents for AutoDome 600 Series
Page 1: ...AutoDome 600 Series Analog PTZ Camera AutoDome 600 Series en Installation Manual ...
Page 2: ......
Page 90: ......
Page 91: ......
