Bosch AutoDome 600 Series, Installation Manual

Page: 54 / 92

54 en | Installing Roof Parapet and Pipe Mounts AutoDome 600 Series Analog PTZ Camera
F.01U.215.782 | 1.0 | 2011.04 Installation Manual Bosch Security Systems, Inc.
8. Insert the Pipe Interface Board into the down pipe and fasten the three (3) retaining
screws to secure the board to the Dome Cap.
Figure 3.13 Pipe Interface Board to Dome Cap Assembly
3.8 Prepare Pendant for Installation
The inside of the pendant housing contains packing material to safeguard the camera during
shipping. You must remove the packing material before attaching the pendant to the mount,
by removing the bubble.
1. Open the top of the box containing the pendant housing, and remove the top foam insert.
2. Remove the pendant housing from the box and from the plastic bag and place the
pendant housing back into the packing box, bubble facing up.
Reserve all packing material in case you must return the unit.
3. Using both hands, apply a clockwise (looking down at the dome) rotational force on the
Pendant Bubble Assembly to set the bubble latch.
4. Insert a small (2 mm) straight blade screw driver into the bubble release opening in the
bubble trim-ring to release the lock, and then remove the screwdriver. See the figure
below.
CAUTION!
Be careful not to strip the threads when tightening the Pipe Interface Board retaining screws.
1 Interface Board
2 Retaining Screws (3)
3 Pendant Mounting Screws (2)