Bosch AutoDome 600 Series, Installation Manual

Page: 84 / 92

84 en | Bubble Handling and Cleaning AutoDome 600 Series Analog PTZ Camera
F.01U.215.782 | 1.0 | 2011.04 Installation Manual Bosch Security Systems, Inc.
To remove the bubble from an in-ceiling housing
1. Loosen the lockscrew (item 1 in the illustration below) in the trim ring using a P1 or
smaller Phillips screwdriver until the bubble can rotate freely.
2. Then rotate the bubble counterclockwise approximately 1/4 turn until it releases from
the In-Ceiling Housing. See the figure below for an illustration.
Figure 7.2 Bubble Release Screw
7.2.2 Cleaning the Bubble Exterior
The exterior of the bubble is hard coated for extra protection. If cleaning becomes necessary,
only use cleaning solutions and cloths suitable for cleaning safety glass lenses. Dry the bubble
thoroughly with a dry nonabrasive cloth to prevent water spots. Never scrub the bubble with
any abrasive material or cleaners.
Do Not:
– Do Not use abrasive or highly alkaline cleaners on the bubble.
– Do Not scrape the bubble with razor blades or other sharp instruments.
– Do Not use Benzene, Gasoline, Acetone, or Carbon Tetrachloride on the bubble.
– Do Not clean bubbles in the hot sun or on very hot days.