AutoDome 600 Series Analog PTZ Camera
Installing the In-Ceiling Mount | en
67
Bosch Security Systems, Inc.
Installation Manual
F.01U.215.782 | 1.0 | 2011.04
6.
Rotate the bubble clockwise until it locks in position. Refer to
Figure 4.11, Page 67
.
Figure 4.11
In-Ceiling Bubble
4.8
Attach Housing to the Interface Box
The In-Ceiling Housing is attached to the Interface Box and secured by two (2) thumbscrews.
Figure 4.12
Attach Housing to Interface Box
1.
Insert the In-ceiling housing through the hole in the ceiling to verify that the edge of the
hole support the unit. Then remove the housing from the hole.
2.
Align the ball studs of the In-Ceiling Housing to the Stud Retainers on Interface Box and
attach.
NOTICE!
The dome bubble comes assembled with a white trim ring. An optional black trim ring is
supplied separately. To replace the white trim ring, remove the four (4) Phillips head screws
from the inner ring and remove the white trim ring. Then place the black trim ring over the
inner ring, and replace and tighten the four (4) screws.
Summary of Contents for AutoDome 600 Series
Page 1: ...AutoDome 600 Series Analog PTZ Camera AutoDome 600 Series en Installation Manual ...
Page 2: ......
Page 90: ......
Page 91: ......
