AutoDome 600 Series Analog PTZ Camera
Installing the Pendant Arm Wall, Corner, and Mast (Pole) Mounts | en
27
Bosch Security Systems, Inc.
Installation Manual
F.01U.215.782 | 1.0 | 2011.04
4.
Connect the 5-pin, 24 VAC to Dome Plug from the Pendant Connector Harness to its
corresponding color mating connector P107 on the right side of the box.
5.
Connect the BNC plug (male connector) of the coax cable with ferrite (refer to
Figure 2.11
, item 2) to the BNC jack connector from the Pendant Connector Harness and
slide its plastic cover over the connection.
Section 2.4.1 Coaxial Cable Connections,
page 17
.
6.
To connect alarm inputs and relay outputs, connect the 4-pin Alarms Out, the 6-pin
Alarms In and the 7-pin Relay connectors from the Pendant Connector Harness to their
mating connectors, installed previously, to the incoming alarm wires.
7.
Connect the 3-pin Power In Plug, installed previously, to its matting connector P101 on
the left side of the box.
8.
If installing a Fiber Optic model attach the incoming ST fiber plug, installed previously, to
its mating connector on the Fiber Optic Module in the power supply box. Then attach the
video BNC plug to the BNC jack (female connector) of the coax cable with ferrite and
slide the plastic cover over the connection. Then, connect the BNC plug (male connector)
of the coax cable with ferrite to the BNC connector from the Pendant Connector Harness
and slide its plastic cover over the connection. Refer to
Section 5 Cable and Wire
Standards, page 70
for fiber optic specifications.
Summary of Contents for AutoDome 600 Series
Page 1: ...AutoDome 600 Series Analog PTZ Camera AutoDome 600 Series en Installation Manual ...
Page 2: ......
Page 90: ......
Page 91: ......
