SMARTLINK
I&II
MDS921AE-10BTS - MDS
Bridge Mode
Before configuration the router in bridge mode
VPI:
VCI:
Encapsulation:
Gateway:
Host Name: (if applicable)
Click Bridge and CPE Side to setup Bridging mode of the Router and then click Next for the next
setting.
This product can be setup two SHDSL mode: CO, Central Office, and CPE, Customer Premises
Equipment. For connection with DSLAM, the SHDSL mode is CPE. For LAN to LAN co
one side must be Co and the other side must be CPE.
LAN Parameters
Enter IP: 192.168.0.1
Enter Subnet Mask: 255.255.255.0
Enter Gateway: 192.168.0.254
The Gateway IP is provided by ISP.
Enter Host Name: SOHO
Some of the ISP requires the host nam
identification. You may check with ISP to see if
your Internet service has been configured with a
host name. In most cases, this field can be
ignored.
WAN1 Parameters
Enter VPI: 0
Enter VCI: 32
Click LLC
Click Next.
S957AE-10BTS User Manual
Page 24 of 113
Before configuration the router in bridge mode check with your ISP about these information.
(if applicable)
Side to setup Bridging mode of the Router and then click Next for the next
This product can be setup two SHDSL mode: CO, Central Office, and CPE, Customer Premises
Equipment. For connection with DSLAM, the SHDSL mode is CPE. For LAN to LAN co
one side must be Co and the other side must be CPE.
255.255.255.0
192.168.0.254
The Gateway IP is provided by ISP.
Some of the ISP requires the host name as
identification. You may check with ISP to see if
your Internet service has been configured with a
host name. In most cases, this field can be
check with your ISP about these information.
Side to setup Bridging mode of the Router and then click Next for the next
This product can be setup two SHDSL mode: CO, Central Office, and CPE, Customer Premises
Equipment. For connection with DSLAM, the SHDSL mode is CPE. For LAN to LAN connection,
