64
ADVANCED USE MANUAL DD700
Activate the paper finished sensor
The sensor is positioned on the paper roll guide and detects when the paper is
finished. To enable the sensor, select
YES
, otherwise select
NO
.
Cut Type
Determine the cutter mode at the end of each printout.
If you select:
NO
no cut is made;
Partial
a partial cut is made;
Complete
a complete cut is made.
STB60
Thermal printer
Tape Ejection: YES, NO
This advances the printing module to position it correctly for tearing.
Module Type
This defines the type of printer module, which can be
Tape, Label
Print Density
Determine the print density:
Very light, Light, Norm, Dark, Very dark
Label Ejection
This ejects the label at the end of every printing operation and realigns the next
label.
If you select:
Automatic
label ejection is automatic;
Software
label feed is controlled by the terminal;
NO
label ejection followed by alignment is not managed.
ITALORA:
WITTY
216,
WITTY218,
SMART830,
Witty2000
Thermal printer.
Model:
WITTY216, WITTY218, SMART830,Witty2000
Head Resolution (dots/mm): 6, 8
Label Width (mm):
102 (default value and maximum settable value).
It must be set according to the instructions in the user manual, in the chapter on
Using the terminal.
label Length (mm):
74 (default value). 213 mm is the maximum settable value.
It must be set according to the instructions in the user manual, in the chapter on
Using the terminal.
Peeling (dots):
40 (default value). 255 dots/mm is the maximum settable value.
It must be set according to the instructions in the user manual, in the chapter on
Using the terminal.
Each adhesive label is automatically printed, peeled off of the paper and presented
to the operator.
