85
ADVANCED USE MANUAL DD700
List of customised hotkeys
If the archive does not exist the message "No hotkey" is displayed.
General data on display
DATA 1: Product code
(where 1 is the number associated to the data that the value was entered for
and Product code is the description of the data)
MES 1: Product code
(where 1 is the number associated to the description of the set data
and product code is the description of the data)
3.7.6
Analogue Terminal/Output Test
To calibrate the powered output connect a 10V tester to the terminals. Adjust the output from the
keys reported on the display until the voltage reads 0 and 10V.
For calibration in current, proceed in the same way but using an ammeter.
To perform both calibrations (current and voltage) you can also choose Complete Calibration from
the menu.
3.7.7
Terminal/Battery Test
The voltage of the internal lithium battery is reported.
3.7.8
Modbus-RTU
E 'can view the list of available variables for this protocol, separated in specific areas Output, Input,
input lines, output lines.
While viewing you can get a summary transmission / printing, pressing the PRINT button.
Note; the numbering of the variables is related to the internal register numbering system, which
differs by 1 from the indication of the addresses given in the variable table in section 2.2.21 Mobus
RTU; in that table shows the addresses in commands on the bus.
3.7.9
Fieldbus board
E 'can view the list of available variables for this option and the specific connection parameters for
the assembled board model.
The variables are displayed in the menu relating to specific areas of the Output and Input; when
viewing is possible to obtain a composite transmission / printing, pressing the PRINT button.
Note; the numbering of the variables is referred to the internal numbering of the registers, which
differs by 1 than the real memory address.
3.7.10 FTDI device
Show the firmware version currently on the internal USB device management host.
