87
ADVANCED USE MANUAL DD700
3.8.2
Setup Menu/Repeater scale/Repeater scale parameters/String
In order to establish communication between main terminal and repeater, the settings of the
parameters listed below must be the same as those on the main terminal.
Extended
See dedicated paragraph.
Communication
It is possible to select the type of communication between repeater and main
terminal:
Full-duplex
: the communication signals can be transferred simultaneously in
both directions;
Half-duplex
: the signals can only flow in a single direction at a time on the
transmission line.
Automatic printing
Select
YES
to enable automatic printing for the extended string, otherwise select
NO
.
If you select automatic printing, it is necessary to enable OUTPUT 01 as
SETPOINT.
Ranges
It is possible to view the field set during installation.
Division
It is possible to view the division value (expressed in the selected unit of
measurement) selected during installation.
Capacity
It is possible to view the capacity set during installation.
1st field Capacity
It is possible to view the 1st field capacity set during installation.
2nd field Capacity
It is possible to view the 2nd field capacity set during installation.
Secondary range
Unit of measurement
: kg, g, t, lb e oz
Division
Capacity
1st field Capacity
2st field Capacity
CB
See dedicated paragraph.
Unit of measurement
It is possible to view the selected unit of measurement chosen during installation.
Division
It is possible to view the minimum division value (expressed in the selected unit of
measurement) selected during installation.
Visual
See dedicated paragraph.
