BIG ASS FANS BAFWorks 3.0, Installation Manual

Page: 51 / 84

BAFWORKS
®
INSTALLATION GUIDE
45
WWW.BIGASSSOLUTIONS.COM ©2013 DELTA T CORP. ALL RIGHTS RESERVED
BAFWORKS
®
INSTALLATION GUIDE
Setting Up the BAFWorks
®
Application
WARNING: The BAFWorks
®
Admin Lock feature is not a suitable replacement for proper lockout/tagout procedures as
prescribed in OSHA standard 29 CFR 1910.147. Before servicing equipment connected to the BAFWorks system, ensure
proper procedures have been taken to isolate equipment to be serviced. These procedures MUST be followed even if the
Admin Lock feature is enabled for a device in the BAFWorks application.
Adding output and input modules
To add and configure an ADAM 6160 output module:
1. If necessary, open BAFWorks.
2. In the top left corner of any screen of the BAFWorks application, touch Edit .
3. Enter the admin lock password, and then touch OK . Note: The default admin lock password is 1271. See page 55 for instructions on
changing the password.
4. In the top left corner of the screen, touch Modules (Figure 1). The All Modules page appears (Figure 2).
5. If necessary, touch
Add Modules
at the bottom of the All Modules page (Figure 2).
6. Enter a name for the module, select the module type ( ADAM 6160 ), and enter the module’s IP address (Figure 2). Ensure all module
IP addresses are recorded on page 58 of this manual and on page 28 of the BAFWorks User Guide.
7. Touch Save under the output module's settings.
8. If you want to make changes to the module, touch Edit under the module's settings. Touch Delete to delete the module.
9. Touch
Done
at the bottom of the All Modules page, and then touch
Exit
in the top left corner of the screen.
Figure 1–Modules button
Figure 2–All Modules page
Complete all necessary installation, wiring, setup, and configuration steps in all previous chapters before proceeding.