BIG ASS FANS BAFWorks 3.0, Installation Manual

Page: 50 / 84

BAFWORKS
®
INSTALLATION GUIDE
WWW.BIGASSSOLUTIONS.COM ©2013 DELTA T CORP. ALL RIGHTS RESERVED
44
Configuring ADAM Modules (cont.)
5. On ADAM 6117 input modules ONLY, select the input channel range for each channel on the module (Figure 5).
a. In the tree on the left side of the screen, click the module you want to configure.
b. In the module information pane, click the AI tab next to the Module Information tab.
c. In the Range drop-down list under Selected Items , select the type of sensor signal being used. Big Ass Solutions recommends
4–20mA for all field sensors.
d. Select the Apply to All Channels check box, and then click Apply .
6. Remove power from the module, and then move the mode selection switch on the side of the module from “Init” to “Normal.”
7. Reapply power to the module.
8. Repeat steps 3–7 for all connected ADAM modules. After all modules have been configured, shut down the PC.
Note: The APAX utility is useful for troubleshooting data errors encountered within the BAFWorks
®
application, such as erroneous
temperatures and module communication loss. An active channel reports the current signal values within the APAX utility. For the
ADAM 6160 relay output module, individual output channels can be forced on and off to verify device functionality if the iPad
®
is not yet
available for testing or setup (set true, set false).
Recording module information
After you are finished configuring the ADAM modules, record the following information on page 58 of this manual and on page 28 of the
BAFWorks User Guide:
• The IP address of each module
•
The ADAM 6117 channels being used and their functions (indoor floor, indoor ceiling, outdoor)
• The ADAM 6160 channels being used and their functions (light, vent/exhaust fan, louver)
Configuring the modules (cont.)
Figure 5–Selecting the input channel range