TELEPHONE OPERATIONS
If your Installer has enabled the User PINs, you will be
able to control your system via any touch-phone.
Each PIN can be programmed to control specific func-
tions and partitions.
+
PIN N. 1 cannot access the system by telephone.
Ï
All the PINs of the Absoluta 630 control panel, ex-
cept PIN no. 1, can manage the control panel using
a telephone.
You can access the system over the phone:
Ø
by receiving a call from the Control panel (Dialler
mode);
Ø
by calling the Control panel, when the Answering de-
vice facility is enabled (Answer mode).
Remote Access via Dialler mode
If your installer has duly set up your control panel, the
Dialler will send voice messages to the programmed
telephone numbers when Alarm, Tamper, Fault condi-
tions are detected. If you receive a Dialler call, you will
be able to access your system during the call by enter-
ing your
PIN
on the telephone keypad. You can enter
your
PIN
while the message is playing, or during the
pauses between message announcements.
+
If the
Confirm successful calls
option is Enabled,
you must press the
*
(Star) key while the voice
message is still running, otherwise the Control
panel will consider the call “Unsuccessful”, and will
carry out the programmed Actions.
Remote Access via Answer mode
If your installer has set up your control panel to answer
incoming calls, you will be able to access your system
via the
Answering device
facility.
+
You must enable the answering function to access
your system using a remote telephone: for more in-
formation, see "Answering" on page 24 and
"ON/OFF Answering (2.1)” on page 47.
+
Do not use a telephone with a redial button to arm
or disarm your system, as this may put your system
security at risk.
The control panel will answer your call after the pro-
grammed number of rings, then will play the welcome
message and asks you to enter your PIN to access to
the remote control.
Ï
The Absoluta 630 control panel answers after five
rings.
Double Call
If the installer has enabled this function,
the caller must allow at least 2 rings but not more than
the rings set for the other answering device, hang up,
wait for a few seconds and callback within 60 seconds.
The control panel will answer on the first ring of the sec-
ond call.
Ï
The Absoluta 630 control panel does not support
this function.
Typing-in your User PIN
You can type-in your PIN while the message is playing,
or during the pauses between message announce-
ments, regardless of the telephone access mode (Dial-
ler or Answer Mode). To type-in your PIN:
1.
Press
#
.
2.
Enter your PIN.
3.
Press
#
.
If the vocal guide is disabled, when your system recog-
nizes your PIN, it will emit an audible feed back signal
(beep, beep), and will accept commands. If your system
does not recognize your PIN, it will emit an audible error
signal (boop).
If the vocal guide is enabled, a series of messages ex-
plains the procedures for operating the system from a
telephone. The vocal guide must be enabled by the
Installer.
Press
#
to repeat the messages from the start.
+
If you type 10 invalid PINs into the Control Panel, a
tamper is generated and access to the system via
telephone is blocked for 90 seconds: the keypad
will display
Tel. inval.attem
in signal display
mode.
Absoluta Plus and Absoluta 630 TELEPHONE OPERATIONS
65