n
Clear Fault/ Tamper (1.9)
This option will allow you to delete the Zone and Parti-
tion Fault and Tamper memories and set all Alarm sig-
naling devices to Standby.
+
If Alarm signal persists after a
Clear Fault/Tamp
command, the causes of persistent Alarms must
be cleared immediately.
1.
Press
A
or
B
to view the
Clear Fault/Tamp
option.
USER
1.9
Clear Fault/Tamp
2.
Press
ENTER
to select the option:
Clear Fault/Tamp
1=Fau._ 2=Tamp._
3.
Select
1
to delete Faults and/or
2
to delete Tam-
pers, then press
ENTER
to confirm:
Clear Fault/Tamp
Are you sure?
4.
Press
ENTER
to delete Faults and/or Tampers
(memories and active).
Clear Fault/Tamp
Done!
5.
Press
ESC
to step back to the User menu.
+
From “Stand-by status” after entering the User PIN,
if display shows Faults and/or Tamper, you can
press the
OFF
key: the keypad directly will manage
the previous procedure of “Clear Fault/Tamper”.
Program
n
ON/OFF Answering (2.1)
This option will allow you to turn ON/OFF the Answering
device. If the Answering device is ON, the Control panel
will answer incoming calls with a Voice message: your
installer has recorded the required Voice messages for
your system.
1.
Press
A
or
B
to view the
ON/OFF Answering
op-
tion.
USER
2.1
ON/OFF Answering
2.
Press:
Ø
ON
to Enable the Answering device;
Answering System
Enabled
Ø
OFF
to Disable the Answering device;
Answering System
Disabled
Ø
ESC
to step back to the User menu.
+
If the Answering device facility is enabled, an
*
will
be shown on the display directly above the
r
.
Absoluta Plus and Absoluta 630
OPERATIONS FROM LCD KEYPAD
47
