Measure:
• the distance
between the balancing device , in orthogonal
position compared to the piston axis, and the screw
head
On the contrary, regulate the screw
SShould this not be sufficient for the correct closing
cycle of the throttles, check the drain valves.
ENGINE/WIRED ACTUATOR
WIRED ACTUATOR CONTROL
Start:
• the bike
and check with a few gas revolutions that the drain
throttle works as shown in the illustration.
If the inlet and drain throttles do not perform the
correct closing cycle, it is necessary to remove the
wired actuator.
There are 2 types of controls to carry out.
•
2
1
3
4
C
R
• the seat
See "FRAME 4.130" paragraph.
• the tank
See "FRAME 4.118" paragraph.
• the filter box lid
See paragraph "3.10".
CONTROL 1
Remove:
Remove:
• the 2 screws
•
3
3
14
CHK
ADJ
A
5
A
4
C
1
14
STROKE ADJUSTMENT
MEASUREMENT
B
C
Distance between balancing device and screw head
14 mm (0.55 in)
B
C
Summary of Contents for 2009 TREK1130
