Benelli 2009 TREK1130, Workshop Manual

Page: 233 / 582

FRONT FORK
4 71
CHAS
FRONT FORK SHANKS ASSEMBLY
ATTENTION
The removed oil retainer and the dust seal must
not be reused. Before re-assembling, check the
conditions of the guide bushes; if scratches,
replace them. Check that the Teflon coating of
the guide bushes is intact.
ATTENTION
Pay attention to the direction of the oil retainer
, it must be inserted so that the hollow part is
facing the seal ring .
A
11
B
2 Inse Insert in the supporting tube:
• the dust seal
• the dust seal clip
• the oil retainer
• the seal ring
• the lower guide bush
1
A Apply at the end of the supporting tube:
• adhesive tape so that the seat of the upper bush is
covered.
C
3 Manually insert:
• the upper guide bush
®
Slightly lubricate the dust seal and oil retainer
with grease.
a
Remove the adhesive tape applied on the end of
the fork shank, eliminating any traces of adhesive.
b
Delicately introduce the fork shank inside the fork
sleeve, being careful not to damage the upper
guide bush.
c
D
E
2
A
B
C
D
E
D
NOTE:
Should the insertion of the guide bush result
difficult to carry out manually, help yourself by
inserting a sharp screwdriver inside the slot of the
bush.
E
3
E
Recommended lubricant
TUTELA MR2 GREASE
LS
C