BECKWITH ELECTRIC M-4272, Instruction Book

Page: 114 / 217

System Setup and Setpoints – 4
4–3
8. Input the desired Comm Access Code
as follows:
a. Utilizing the Up and Down arrow
pushbuttons select the desired first
digit.
b. Press the Left arrow pushbutton once,
then repeat the previous step as
necessary to input the desired Comm
Access Code digits.
c. When the desired Comm Access Code
has been input, then press
ENTER .
The following will be displayed:
COMM ACCESS CODE
ACCESS eth eth_ip
9. Press Exit.
USER ACCESS CODES
The MBTS includes three levels of access codes.
Depending on their assigned code, users have
varying levels of access to the installed functions.
1. Level 1 Access = Read setpoints,
monitor status, view status history.
2. Level 2 Access = All of level 1
privileges, plus read & change
setpoints, target history, set time
clock.
3. Level 3 Access = All of level 2
privileges, plus access to all
configuration functions and settings.
Each access code is a user-defined one-to four-
digit number. Access codes can only be altered by
a level 3 user.
If the level 3 access code is set to 9999, the
access code feature is disabled. When access
codes are disabled, the access screens are
bypassed, and all users have full access to all the
MBTS menus. The device is shipped from the
factory with the access code feature disabled.
ISScom ® User Access Codes Setup
To set the MBTS User Access Codes perform the
following:
NOTE : Communication must be established with
the target MBTS for this procedure.
1. From the ISScom Main Screen menu
select
Tools/System Access Code/
User Access . ISScom will display the
User Access Code Reset dialog screen
(Figure 4-3).
Figure 4-3 User Access Codes Reset Dialog
Screen
2. Enter the desired New User Access Code
(1-9999), then re-enter (confirmation) the
New User Access Code.
3. Select OK , ISScom will display a New
User Access Code Sent Confirmation
Screen (Figure 4-2).
Figure 4-4 New User Access Code Sent
Confirmation Screen
4. Select OK , ISScom will return to the
Main Screen.