Baroness LM551, Service Manual, Page: 181 / 213

Install the pad support and pad of the
carrier through the groove of the housing.
7
6
1
3
2
4
5
ikhpjf-011
Installation of Brake Caliper_005
1 Housing
2 Pad (cam)
3 Pad support (cam)
4 Pad (carrier)
5 Pad support (carrier)
6 Carrier hole
7 Housing groove
Insert a chip of corrugated cardboard
between the pads of the cam and carrier to
keep the pads in the correct positions.
Install the assembled top and bottom
calipers into the wheel mount (disc rotor
part) while removing the corrugated
cardboard.
2
1
2
3
ikhpjf-005
Installation of Brake Caliper_006
1 Wheel mount (disc rotor part)
2 Caliper
3 Corrugated cardboard
6.
7.
8.
Follow the steps below to install the wheel
mount.
Check the position of the key of the
wheel motor.
Align the key groove of the wheel mount
with the key of the wheel motor.
Install the wheel mount with the top and
bottom calipers installed into the shaft of
the wheel motor while holding it with both
hands.
At this time, align the groove of the
bottom caliper with the mount bracket
first and push in the wheel mount a little.
Next, align the groove of the top caliper
with the mount bracket and push in the
wheel mount a little.
If the key groove of the wheel mount
does not fit, turn the wheel mount and
confirm that the position fits, and then
push the top and bottom calipers in along
the mount bracket all the way.
1
3
4
3
4
2
ikhpjf-006
Installation of Brake Caliper_007
1 Wheel motor shaft
2 Wheel mount
3 Mount bracket
4 Caliper groove
9.
[1]
[2]
[3]
[4]
[5]
Main Vehicle
LM551
Main Vehicle
Page 6-37
Removal and Installation of Each Section