84
LED-PRO • User’s Guide
4. Operation
Using the Expert Mode Menu
•
Enable
the “minimum delay” mode when an another image processor (such as an
Encore or ScreenPRO-II) is used to process the video and create multiple
windows. The external processor then feeds LED-PRO in a progressive 800x600
format. In this case, LED-PRO does not need to scale the image, and operates in
a “minimum delay” mode so as not to introduce additional delay into the system.
For the “minimum delay” function to work properly:
•
V Lock
or
HV Lock
must be enabled on the
Lock to Source Menu
.
•
V Size
on your input must match
V Size
on the output.
On the
Mode
line, enable or disable Minimum Delay.
•
When
Off
, status is
n/a
, and the delay through the system is no greater that 1.5
frames.
•
When
On
, delay through the system is a maximum 20 lines, and status reads
“
Active
.”
p~îÉ=`çåÑáÖ
From the
LED Output Menu
, select
Save Config
to save all current output configuration
settings in non-volatile memory. The message “
Saving Configuration
” is shown. Note
that there is only
one
output configuration file.
Once saved, the output values are retained across power cycles. If you do not save the
parameters, the information will not be restored upon the next system power up.
Please note the following important point regarding the
LED Output Menu
:
•
If you change any parameter in the
LED Output Menu
, but you do not save the
changes (using the
Save Config
function), the “
Save Output Configuration
”
message will be shown when you attempt to exit the menu:
Figure 4-67.
Save Output Configuration Message
~
Press
SEL
to save the changes.
~
Press
ESC
to continue operations without saving changes.
oÉëÉí=`çåÑáÖ
From the
LED Output Menu
, select
Reset Config
to remove all user-entered configuration
settings, and restore the default values for the current output format. The message
“
Resetting Configuration
” is shown.
Note that this command also clears the saved configuration (if any), so that the system will
not restore the unwanted configuration at power up.
Note
If either of the two prerequisites are not met, an error
message will be shown.
S a v e O u t p u t C f g ?
< S E L > = Y e s
< E S C > = N o
Summary of Contents for Led Pro
