Barco Led Pro, User Manual

Page: 72 / 186

58 LED-PRO • User’s Guide
4. Operation
Using the Setup Wizard
~
If the system detects “creative” LED tiles, such as MiSPHERE and
MiPIX, the message “
Tile type not supported ” will appear. Because
these tile types are not supported by the Wizard, please use Director
Toolset for setup.
6. From the Wall Information Menu , select Next to display the Set Wall
Dimensions Menu , which allows you to set the number of horizontal and vertical
tiles in the wall:
Figure 4-34. Set Wall Dimensions Menu (sample)
7. Enter the number of horizontal and vertical tiles, and press NEXT .
~
If the LED tile count is correct, the Wall Data Connection Menu will be
shown. Please continue with step 8 .
~
If the LED tile count (as entered) is incorrect, the Tile Count Mismatch
Menu is shown.
Figure 4-35. Tile Count Mismatch Menu (sample)
Press SEL to return to the Set Wall Dimensions Menu , and enter the
correct number of horizontal and vertical tiles. Please note:
• If you enter fewer tiles than are actually detected, the system
“loops” back to the
Set Wall Dimensions Menu .
• If you enter more tiles than are actually detected (and you do
this three times), a test pattern will appear to enable you to
visually check the wall for errors. At this point, check all power
and data cabling, and press
SEL to continue with a repeat of
the “detection” process.
Note If any of the errors listed above are detected more than once,
the system will request that you contact
Technical Support .
S e t W a l l D i m e n s i o n s :
> H o r i z o n t a l t i l e s :
4
V e r t i c a l t i l e s : 5
N e x t
T i l e C o u n t M i s m a t c h .
D e t e c t e d C o u n t : 2 0
E n t e r e d C o u n t : 1 6
P r e s s < S E L > t o f i x