Barco Led Pro, User Manual

Page: 65 / 186

LED-PRO • User’s Guide 51
4. Operation
Using the Setup Menu
opOPO
From the Setup Menu , select RS232 to display the RS232 Menu , which enables you to set
the baud rate for the rear panel RS-232 connector.
Figure 4-23. RS232 Menu (sample)
„
To set the RS-232 connector’s baud rate:
1. On the Baud line, press SEL . The navigation cursor ( > ) changes to the edit
cursor ( # ).
2. Choose the desired baud rate with the knob, and “accept” it by pressing SEL .
Choices include 19200, 38400, 57600 and 115200. Note that the selected Baud
rate is not updated until the
SEL button is pressed.
bñéÉêí=jçÇÉ
From the Setup Menu , select Expert Mode to display the Expert Mode Menu , which
provides extensive “advanced” system setup functions. Refer to the “ Using the Expert
Mode Menu ” section on page 66 for full instructions.
p~îÉ=póëíÉã=pí~íÉ
From the Setup Menu , select Save System State to perform the following functions:
•
Save all input, output and system settings in non-volatile memory — so they can
be restored at power up.
•
Save a specific input so that it will be acquired and selected at power up. By
default, input 1 is selected at bootup and after a factory reset.
R S 2 3 2
> B a u d
1 9 2 0 0
Note Most operations will be performed at 19200.
Note If LED-PRO is placed in Remote mode and Director Toolset
is connected, the Director Toolset may update the RS232
Menu with a different setting, such as 115200.
Note When the Status Menu is next selected, the message “ Last
Saved [1, 2, 3 or 4]” appears on line 2, depending upon which
input is selected.
Note If you do not perform the “ Save System State ” function,
some system information may not be restored upon the next
system power up.