Barco Led Pro, User Manual

Page: 118 / 186

104 LED-PRO • User’s Guide
4. Operation
Using the LED Menu
opOPO
From the LED Menu , select RS232 to display the RS232 Menu , which enables you to set
the RS-232 baud rate for the Serial port — not the Diagnostic port. The Serial port is
used for communications with the Director Toolset.
Figure 4-86. RS232 Menu (sample)
•
Select the Baud field to set the Serial port’s baud rate.
p~îÉ=`çåÑáÖ
On the LED Menu , select Save Config to save all current output configuration settings in
non-volatile memory.
oÉëÉí=`çåÑáÖ
On the LED Menu , select Reset Config to remove all user-entered configuration settings,
and restore the default values for the current output format.
R S 2 3 2
> B a u d
1 9 2 0 0
Note This function is identical to the Save Config function located
in the Output Setup Menu ( SETUP > Expert Mode >
Output ). Refer to the “ Save Config ” section on page 84 for
instructions.
Note This function is identical to the Reset Config function located
in the Output Setup Menu ( SETUP > Expert Mode >
Output ). Refer to the “ Reset Config ” section on page 84 for
instructions.