Barco Led Pro, User Manual

Page: 84 / 186

70 LED-PRO • User’s Guide
4. Operation
Using the Expert Mode Menu
Please note:
•
The 1:1 mode requires very accurate settings, as even a small sampling error can
cause noise on the output image.
•
Both the sample clock frequency and phase must be correct to obtain a properly
sampled image.
•
LED-PRO incorporates automatic adjustments in the 1:1 sampling mode.
„
To change the sampling mode:
1. On the Input Setup Menu , select Sampling .
2. Choose either OverSample or 1:1 , and press SEL to accept.
Please note:
•
1:1 is the default setting.
•
The OverSample option is only available for RGB and YPbPr analog inputs. All
other input types have defined sample clocks that are inherently 1:1. If the input is
set to one of the other types, the value for this selection will be “
n/a .”
qáãáåÖ=^Çàìëí
From the Input Setup Menu , select Timing Adjust to display either the 1:1 Timing Adjust
Menu or the OverSample Timing Adjust Menu — depending on your selected sampling
mode. Each menu allows for exact positioning of the input signal's active area.
•
1:1 Timing Adjust Menu
•
OverSample Timing Adjust Menu
„ NWN=qáãáåÖ=^Çàìëí=jÉåì
When 1:1 sampling is selected, the 1:1 Timing Adjust Menu is shown:
Figure 4-52. 1:1 Timing Adjust Menu (sample)
Following are descriptions of each menu function, which are only available when 1:1
Sampling is selected, and the input is analog RGB or YPbPr .
•
Auto Config — causes the system to run the “ 1:1 active area acquisition ”
procedure.
1 : 1 T I M I N G A D J U S T
> A u t o C o n f i g
S a m p l e P h a s e 0
H T o t a l 2 1 6 0
H P o s i t i o n 4 9 6
H A c t i v e 1 6 0 0
V T o t a l 1 2 5 0
V P o s i t i o n 4 9
V A c t i v e 1 2 0 0
Note For the Auto Config procedure to function correctly, the input
source for the selected channel must have 50% gray or
brighter pixels around all four edges of the active area.