Barco Led Pro, User Manual

Page: 36 / 186

22 LED-PRO • User’s Guide
3. Installation
Signal Installation
~
If you are using RS-232 communications, connect the laptop to LED-
PRO’s
RS-232 Port .
~
If you are using Ethernet communications, a totally “local” network is
recommended, without IP connections to the outside world:
• Use a crossover Ethernet cable for a direct connection, or
• Use a standard Ethernet cables in conjunction with an Ethernet
hub or switch.
3. Ensure that your LED wall is properly assembled, and that all data cables are
connected to all tiles — in the proper sequence. Refer to your specific LED tile’s
“
User’s Guide ” for details.
4. Connect LED-PRO’s LED Interface output to the data input of your LED wall.
Please note:
~
Use the proper cable, depending upon your LED wall’s input connector
(e.g., DVI or MDR). Refer to the “
Cable and Adapter Information ” on
page 18 for details on all connection cables.
~
( Option ) If you are using a fiber optic link:
• Ensure that power is properly connected to all Fiberlink units.
• Connect LED-PRO’s LED Interface output to the input of the
Fiberlink Transmitter.
• Connect a fiber optic cable from the output of the Fiberlink
Transmitter to the input of the Fiberlink Receiver.
• Connect the output of the Fiberlink Receiver to the data input of
your LED wall.
5. ( Option ) If you are using the Barco AEC:
~
Ensure that power is properly connected to the AEC.
~
Connect the data output of your LED wall to the input of the AEC.
Please continue with system setup, menu orientation and operations, as outlined in
Chapter 4, “
Operation ” on page 25.
Note A 15 meter RS-232 cable is provided, which will assist you in
viewing the LED wall while simultaneously using your laptop
for calibration purposes.