Baldor VS1MXS51, Installation & Operating Manual

Page: 40 / 88

7-6 Parameter Descriptions MN762S
Par No. Description Range Units Default Explanation
P2-17
Start Mode
Select



to 
- Auto-0
Edge-r: Following Power on or
reset, the drive will not
start if Digital Input 1
remains closed. The
Input must be closed
following a power on or
reset to start the drive.
Auto-0: Following a Power
On or Reset, the drive
will automatically start if
Digital Input 1 is closed.
Auto 1 to 5: Following a Fault,
the drive will make up
to 5 attempts to restart
at 20 second intervals.
The drive must be
powered down to reset
the counter.
P2-18
Spin Start
Enable
0: Disabled
1: Enabled
- 0
When enabled, on start up the
drive will attempt to determine if
the motor is already rotating, and
will begin to control the motor
from its current speed. A short
delay may be observed when
starting motors which are not
turning.
P2-19
Keypad Restart
Mode
0: Minimum
Speed, Edge-r
1: Previous
Speed, Edge-r
2: Minimum
Speed, Auto-r
3: Previous
Speed, Auto-r
- 1
Active when P1-07 = 1 or 2
0: Following a stop and restart,
the drive will run at minimum
speed.
1: Following a stop and restart,
the drive will run at the last
set point speed.
2: As per setting 0, except
that the Run command will
be determined by the status
of Digital Input 1, and the
user is not required to press
the keypad start button.
3: As per setting 1, except
that the Run command will
be determined by the status
of Digital Input 1, and the
user is not required to press
the keypad start button.
Table 7-2 Parameter Group 2 - Extended Parameters Continued