Baldor ID15J1F50-ER, Installation And Operating Manual

Page: 64 / 89

MN715J Troubleshooting 5-5
Table 5-1 Fault Messages
FAULT MESSAGE DESCRIPTION
Invalid Base ID Failure to determine control horsepower and input voltage configuration from
the Power Base ID value in software.
Commun Timeout Communication failure between interface board and motor control.
2 SEC Overload
*
Output current exceeded 3 second rating.
1 MIN Overload
*
Output current exceeded 1 minute rating.
CUR LIM Timeout Peak output current exceeded PK CURRENT LIMIT parameter value.
HW Surge Current High output current condition detected (greater than 250% of rated output
current).
Heat Sink Temp Control heatsink exceeded upper temperature limit.
Hardware Protect A general hardware fault was detected but cannot be isolated. Ground Fault
detected (output current leakage to ground) or power supply undervoltage.
Regen RES Power Regen power exceeded dynamic brake resistor rating.
Precharge FLT DC Bus charging error detected.
Bus Overvoltage High DC Bus voltage.
Bus Undervoltage Low DC Bus voltage.
Software VER FLT Keypad and control software versions are incompatible.
External Trip Connection between J4-17 and J4-18 is open.
FE EEPROM Error Non-volatile memory on the keypad has failed.
New Base ID Control board detected a change in the Power Base ID value in software.
*
Note: An overload fault cannot be reset (cleared) until the “% OVERLOAD LEFT”
counter reaches 100%.