Baldor ID15J1F50-ER, Installation And Operating Manual

Page: 45 / 89

4-8 Programming and Operation MN715J
Program Mode
Use the Program Mode to customize the control for a variety of applications
by programming the operating parameters. In the Display Mode, press the
PROG key to access the Program Mode. To return to the Display Mode,
press the DISP key. Note that when a parameter is selected alternately
pressing the DISP and PROG keys will change between the Display Mode
and the selected parameter. Parameters may be programmed in any
operating mode. When a parameter is selected for programming, the keypad
display gives you the following information:
Parameter Status
Parameter
Value and Units
#
Parameter Status
All programmable parameters are displayed with a P: in the lower left hand
corner of the keypad display. If a parameter is displayed with a V:, the setting
may be viewed but not changed while the motor is operating. If the parameter
is displayed with an L:, the setting is locked and the security access code
must be entered before any changes can be made.
Parameter Blocks Access for Programming
Use the following procedure to access parameter blocks to program the
control.
Action Description Display
Apply Power If no faults and programmed for
LOCAL operation.
If no faults and programmed for
REMOTE operation.
If fault is displayed, refer to the
Troubleshooting section of this
manual.
Press PROG key
Press Y or B key Scroll to the ACCEL/DECEL
block.
Press
Y
or
B
key
Scroll to the Level 2 Block.
Press ENTER key First level 2 block display.
Press Y or B key Scroll to Programming Exit menu.
Press ENTER key Return to display mode.