Baldor ID15J1F50-ER, Installation And Operating Manual

Page: 33 / 89

3-22 Receiving and Installation MN715J
3 Speed Analog 2 Wire Connection
Figure 3-16 3 Speed Analog 2 Wire Connection Diagram
11
12
13
14
15
16
17
18
Forward
Reverse
Analog Select
Speed Select 1
Speed Select 2
Run Command
Speed Command
Input Common
J4
Refer to Table 3Ć11
See recommended terminal
tightening torques in Section 6.
Table 3-11
Function Speed Select 1 Speed Select 2
ANA CMD Select Open Open
Preset
Speed 1 Closed Open
Preset
Speed 2 Closed Closed
Preset
Speed 3 Open Closed
J4-11 OPEN motor decels to stop (depending on Keypad Stop mode).
CLOSED starts Forward motor rotation.
J4-12 OPEN motor decels to stop (depending on Keypad Stop mode).
CLOSED starts Reverse motor rotation.
J4-13 OPEN selects setting of “ANA CMD Select” parameter.
CLOSED selects Analog Input #1.
J4-14 Selects preset speeds as defined in Table 3-11.
J4-15 Selects preset speeds as defined in Table 3-11.
J4-16 OPEN selects direction commands from Keypad.
CLOSED selects direction commands from terminal strip.
J4-17 OPEN selects speed commanded from Keypad.
CLOSED selects terminal strip speed source (selected in the Level 1 Input block,
ANA CMD Select parameter).