Baldor ID15J1F50-ER, Installation And Operating Manual

Page: 35 / 89

3-24 Receiving and Installation MN715J
EPOT 2 Wire Connection
Figure 3-18 Electronic POT 2 Wire Connection Diagram
11
12
13
14
15
16
17
18
Forward
Reverse
EPOT/CMD Select
Accel/Decel Select
Increase
Decrease
External Trip
Input Common
Refer to Figure 3Ć9.
J4
See recommended terminal
tightening torques in Section 6.
J4-11 OPEN motor decels to stop (depending on Keypad Stop mode).
CLOSED to enable operation in the Forward direction.
J4-12 OPEN motor decels to stop (depending on Keypad Stop mode).
CLOSED to enable operation in the Reverse direction.
J4-13 OPEN for normal speed mode. Terminal strip speed source is selected in the
Level 1 Input block, ANA CMD Select parameter.
CLOSED to enable the Electronic Potentiometer Mode.
J4-14 OPEN selects ACC / DEC / S-CURVE group 1.
CLOSED selects group 2.
J4-15 Momentary CLOSED increases motor speed while closed.
J4-16 Momentary CLOSED decreases motor speed while closed.
J4-17 If J4-17 is connected, you must set Level 2 Protection block, External Trip to
“ON” to activate the opto input.
OPEN causes an external trip fault. The control will disable and the motor
coasts to a stop. An external trip fault is displayed (also logged in the fault log).
CLOSED allows normal operation.