Baldor ID15J1F50-ER, Installation And Operating Manual

Page: 21 / 89

3-10 Receiving and Installation MN715J
115VAC 1 Phase Wire Size and Protection Devices
Table 3-6 Wire Size and Protection Devices - 1 phase
Input Fuse Wire Gauge
Control Output
Input Fuse Wire Gauge
Control Output
Rating HP
Fast Acting
Amps
Time Delay
Amps
AWG mm 2
0.33 10 10 14 2.08
0.5 10 10 14 2.08
0.75 15 10 14 2.08
1.0 20 15 14 2.08
Note: All wire sizes are based on 75
°
C copper wire, 1% line impedance. Higher
temperature, smaller gauge wire may be used per NEC and local codes.
Recommended fuses are based on 40
°
C ambient, maximum continuous
control output current and no harmonic current.
Figure 3-5 Single Phase AC Power and Motor Connections
L1 N Earth
* AC Motor is not provided with control.
Baldor Series 15J Control
Metal conduit should be used to shield
output wires (from T1, T2, T3 of control to
T1, T2, T3 of motor).
T1 T2 T3
T1
T2 T3
G
Shield wires inside
a metal conduit.
Motor wire should be sized using the 3
phase information in Table 3Ć4.
* Optional components not
provided with 15J Control.
L1 L2 L3
* Optional
Fusing