Baldor ID15J1F50-ER, Installation And Operating Manual

Page: 13 / 89

3-2 Receiving and Installation MN715J
Optional Remote Keypad Installation
Note: Requires phone jack connector on the control board. Some models may not
have a phone jack installed. If the phone jack is not installed and you wish to
connect a remote keypad, contact Baldor.
A separate keypad may be remotely mounted using an optional Baldor
keypad extension cable (in addition to the keypad within the control). Keypad
assembly (CBLSM015KP - 5 ft, CBLSM046KP - 15 ft or CBLSM091KP - 30 ft)
comes complete with the extension cable and gasket required to mount it to
an enclosure. When the keypad is properly mounted to a NEMA Type 4X
indoor enclosure, it retains the Type 4X indoor rating.
Tools Required:
•
Center punch, tap handle, screwdrivers (Phillips and straight) and
crescent wrench.
•
8-32 tap and #29 drill bit (for tapped mounting holes) or #19 drill
(for clearance mounting holes).
•
1-
1
/
4
″
standard knockout punch (1-
11
/
16
″
nominal diameter).
•
RTV sealant.
•
(4) 8-32 nuts and lock washers.
•
Extended 8-32 screws (socket fillister) are required if the mounting
surface is thicker than 12 gauge and is not tapped (clearance mounting
holes).
•
Remote keypad mounting template. A tear out copy is provided at the
end of this manual for your convenience. (Photo copy or tear out.)
Mounting Instruction: For tapped mounting holes
1. Locate a flat 4
″
wide x 5.5
″
minimum height mounting surface. Material
should have sufficient thickness (14 gauge minimum).
2. Place the template on the mounting surface or mark the holes as shown.
3. Accurately center punch the 4 mounting holes (marked A) and the large
knockout (marked B).
4. Drill four #29 mounting holes (A). Thread each hole using an 8-32 tap.
5. Locate the 1- 1 /
4
″
knockout center (B) and punch using the manufacturers
instructions.
6. Debur knockout and mounting holes making sure the panel stays clean
and flat.
7. Apply RTV to the 4 holes marked (A).
8. Assemble the keypad to the panel. Use 8-32 screws, nuts and lock
washers.
9. From the inside of the panel, apply RTV over each of the four mounting
screws and nuts. Cover a 3 /
4
″
area around each screw while making
sure to completely encapsulate the nut and washer.