Baker Hughes Panametrics AquaTrans AT600, User Manual

Page: 43 / 174

AquaTrans™ AT600 User’s manual 33
Chapter 4. Initial setup and programming
If the first value is set to time, the meter displays the time unit. If the first value is set to forward totals, reverse totals, or
net totals, the meter displays the selected unit in the units setting selection. The available time measurement units
are seconds, minutes, hours or days. To choose the appropriate units, from the highlighted measurement type, press
the [

] or [

] keys until the desired measurement unit is highlighted.
Note:
If you selected time, the available units are seconds, minutes, hours and days.
4.3.4 Starting or stopping the totalizer measurement
To start or stop totalizer measurements:
After the unit is highlighted, press [√] to open the
display/unit option.
Press the [

] and [

] keys to scroll to the desired units,
and press [√] to select the unit, and then press [√]
again to confirm the selection or [x] to cancel the
selection.
From the display, press either the [

]
or [

] keys until the start/stop icon
(either an arrow icon for start or a
two-bar icon for stop) is highlighted.
After the value is highlighted, press [√]
to start or stop totalizing.
The display icon then changes to
indicate the new status (start or stop).