Baker Hughes Panametrics AquaTrans AT600, User Manual

Page: 83 / 174

AquaTrans™ AT600 User’s manual 73
Chapter 4. Initial setup and programming
4.7.11 Enter the path when wetted selected
IMPORTANT: Changing the transducer spacing should only be completed according to instructions received from
the factory.
Select path and press [√]. The following
screen opens.
In the sensor setup menu, select path length
or axial length and press [√]. A screen similar
to the following opens.
Press [√] again. Enter this path use in
installing your transducers on the pipe. The
calculation is based on your sensor setup
input (pipe, transducer, fluid, and traverses).
Use the [

] or [

] key to select a specific digit,
then use the [

] or [

] key to change that
digit as required. After all digits are correct,
press [√] to save. Then, press [x] to return to
the previous screen.