Baker Hughes Panametrics AquaTrans AT600, User Manual

Page: 82 / 174

Chapter 4. Initial setup and programming
72 AquaTrans™ AT600 User’s manual
4.7.10 Calculating the path when clampon selected
Note: If setting the calculated spacing for your transducers is not possible, contact the factory for assistance. Only if
instructed by the factory, press [√] again, and a screen similar to the following opens.
IMPORTANT: Changing the transducer spacing should only be completed according to instructions received from
the factory.
Select path and press [√]. The following
screen opens.
Press [√] again. Record this calculated
transducer spacing for use in installing your
transducers on the pipe. The calculation is
based on your sensor setup input (pipe,
transducer, fluid, and transducers).
Use the [

] or [

] key to select a specific digit,
then use the [

] or [

] key to change that
digit as required. After all digits are correct,
press [√] to save. Then, press [x] to return to
the previous screen.