Baker Hughes Panametrics AquaTrans AT600, User Manual

Page: 62 / 174

Chapter 4. Initial setup and programming
52 AquaTrans™ AT600 User’s manual
Note:
The units shown are the units selected in the units setting menu.
Test the alarms
4.6.3 Programming the Modbus/service port
Press [√] again, and a screen
similar to the following opens.
Use the [

] or [

] key to select a specific digit, then
use the [

] or [

] key to change that digit as
required. After all digits are correct, press [√] to
save. Then, press [x] to return to the previous screen.
To test the alarms output, select
test alarms and press [√]. The
following screen opens.
Select OFF to disable the alarm or
ON to enable the alarm. To begin
testing, select ON and press [√]. To
stop testing, press [x].
The Modbus/service port is configured at the factory as follows:
• Baud rate = 115200
• Bits/parity = 8/none
• Stop bits = 1
• Address = 1
To view the settings for the Modbus/service port, select it on the
input/ output screen and press[√].