Avocent MERGEPOINT 53XX SP MANAGER, Installer/User Manual

Page: 122 / 204

108
MergePoint Service Processor Manager SP53XX Installer/User Guide
example, to add a service processor user, you must enter
add spmanager user <username>
; the
user must then be configured after adding, using the set command.
Table 7.2: Parameters that Work with the CLI add Command
Parameter Level 1 Parameter Level 2 What It Configures (Syntax)
dhcpd mapping Add a MAC address for IP.
Synopsis: add adhpd mapping <MAC_address>
Example: add dhcpd mapping 00602e01d9a6
NOTE: No colon (:) is needed in the MAC address.
See the set command for the following parameters:
dhcpd setting subnet, dhcpd setting relay and dhcpd
mapping on page 117.
iptables nat | filter Firewall configuration. Add a new rule to NAT table
and filter table.
Synopsis: add iptables nat
[PREROUTING|POSTROUTING|OUTPUT]
<number>| filter [INPUT|OUTPUT|FORWARD]
<chainname>
Example: add iptables nat PREROUTING 0
network interface Add an alias to an interface.
Synopsis: add network interface <interface> alias
<alias_name>
Example: add network interface eth1 alias yd
hosts Add an IP address for a host.
Synopsis: add network hosts <IPaddress>
Example: add network hosts 172.26.25.178
st_routes Add to the list of static route targets a subnet or host
(networks in the form 1.2.3.0/24 or host IPs).
Synopsis: add network st_routes
<network_IPaddress/netmask> | <host_IPaddress>
Example: add network st_routes 1.1.1.1
pxe mapping Add a MAC address.
Synopsis: add pxe mapping <MAC_ address>
Example: add pxe mapping 00602e01d9a6
NOTE: No colon (:) is needed in the MAC address.
See the set command for the following parameters:
pxe mapping and pxe setting on page 120.
snmpd user Add a user and fills in the subtree with default values
and randomly generated passwords.
Synopsis: add snmpd user <user_name>
Example: add snmpd user user1