Avocent MERGEPOINT 53XX SP MANAGER, Installer/User Manual

Page: 120 / 204

106
MergePoint Service Processor Manager SP53XX Installer/User Guide
Pressing
Tab
once after partially typing a parameter name automatically completes the parameter
name, unless there is more than one parameter name beginning with the typed characters. If more
than one parameter name begins with the typed characters, then
Tab Tab
displays them all.
NOTE: The bootconf and cards commands are only for MergePoint SP5324/SP5340 appliance.
Examples
cli> s < Tab >< Tab >
set shell show
cli> se < Tab >
cli> set
cli>
set n
<
Tab
><
Tab
>
network ntp
cli> set ne < Tab >
cli> set network
cli> set network < Tab >< Tab >
hostname hosts interface resolv st_routes
cli> set network i < Tab >
cli> set network interface
cli> set network interface eth0 < Tab >
address alias gateway method mtu netmask
address6 broadcast gateway6 method6 mtu6 netmask6
CLI Commands
The CLI utility supports the commands that are described in the following sections with examples.
cli> <Tab><Tab>
add commit exit list rename set show
cd delete get quit revert shell version
add
The
add
command adds the last parameter and sets it to the default value (if any). Any nondefault
values must be set using the set command.
The
add
command is used instead of
set
when multiple parameters of the same type can exist. For
example, add network hosts <IP address> makes an entry for a host with the specified IP address in
the hosts list. In that case, add is used because multiple hosts can exist.