Avocent MERGEPOINT 53XX SP MANAGER, Installer/User Manual

Page: 130 / 204

116
MergePoint Service Processor Manager SP53XX Installer/User Guide
cli>
version
The
version
command displays the current CLI version.
Synopsis
version
Examples
cli>
version
MergePoint CLI 2.0 (2007-06-16T13:47+1000)
Summary of How to Configure the Top Level Parameters
This section provides a brief overview of how to configure the top level parameters.
Table 7.3 describes which of the top level parameters that you can set without using the
add
command first, and it also shows the parameters that need to be set after the
add
command creates
the parameter to set additional parameters and values.
Table 7.3: Setting Top Level CLI Parameters
Parameter Command
adsap2 Avocent DS Authentication Protocol configuration.
Synopsis: set adsap2 state <secure | trust-all> authserver <ip-address>
Example: set adsap2 state trust-all authserver 2.2.2.2
NOTE: The state of “secure” means the server is being managed by the DSView 3
software, while the state of “trust-all” means the server is unmanaged by the DSView 3
software. The parameter “authserver” specifies the IP address of authorization server.