Avaya CS 1000, Fundamentals

Page: 151 / 270

Updating the DAP firmware
1. Start IP DECT Configurator.
2. In the IP DECT Configurator main window, click General .
3. If you have more than one DECT system configured in IP DECT Configurator, click
Modify , and select the system you want to update.
OR
If you have only one DECT system configured, proceed to step 4.
4. In the General Settings window click Browse .
5. Browse to the folder where the new firmware (the DAP package file) is stored, select
the DAP package file, and click Open .
The new firmware information appears in the DAP Package: field.
6. Click Apply .
7. Click Save system .
8. Click Activate/Deactivate/System status .
9. Ensure the DHCP and TFTP servers are running.
10. Click Reboot to restart the DAPs.
11. Enter the following URL in an internet browser: localhost/cds . The DAP Manager
appears.
12. In the Main panel, click Access Points . The Access Points page appears.
13. On the Access Points page, ensure the new firmware (Package ID) is uploaded
successfully.
Remove and replace a DAP (if a new DAP is available)
Follow this procedure to remove and replace a DAP.
Replacing a DAP
1. Ensure that DAP Manager is running before you begin to replace a DAP.
2. Ensure that the DHCP server and the TFTP server are running in the IP network.
3. Open the DAP Manager Web interface.
4. Click Access Points .
5. Disconnect the DAP you need to replace.
Do not continue this procedure until DAP Manager indicates that the DAP is not
working.
6. Connect the new DAP.
Remove and replace a DAP (if a new DAP is available)
SIP DECT Fundamentals October 2012 151