AutomationDirect DURAPULSE GS3-2010, User Manual

Page: 80 / 316

Chapter 4: AC Drive Parameters
4–12
Communications Parameters
P9.00
Communication Address 01 to 254 01
P9.01 Transmission Speed
00: 4800 baud
01: 9600 baud
02: 19200 baud
03: 38400 baud
01
P9.02
Communication Protocol
00: MODBUS ASCII mode
7 data bits, no parity, 2 stop bits
01: MODBUS ASCII mode
7 data bits, even parity, 1 stop bit
02: MODBUS ASCII mode
7 data bits, odd parity, 1 stop bit
03: MODBUS RTU mode
8 data bits, no parity, 2 stop bits
04: MODBUS RTU mode
8 data bits, even parity, 1 stop bit
05: MODBUS RTU mode
8 data bits, odd parity, 1 stop bit
00
P9.03
Transmission Fault
Treatment
00: Display fault and continue operating
01: Display fault and RAMP to stop
02: Display fault and COAST to stop
03: No fault displayed and continue operating
00
P9.04
Time Out Detection
00: Disable
01: Enable
00
P9.05
Time Out Duration 0.1 to 60.0 seconds 0.5
P9.07
Parameter Lock
00: All parameters can be set and read
01: All parameters are read-only
00
P9.08
Restore to Default 99: Restores all parameters to factory defaults 00
* Some parameters and settings are available only in later firmware versions of DURA
PULSE
drives. Refer to
the beginning of this “DURA
PULSE
Parameter Summary” section for more information.
Parameter can be set during RUN Mode.
Parameter Summary (continued)
Parameter
*
Description Range*
Default
Setting User
Setting
Display Parameters
P8.00
User Defined Display
Function
00: Output Frequency (Hz)
01: Motor Speed (rpm)
02: Scaled Frequency
03: Output Current (A)
04: Motor Load (%)
05: Output Voltage (V)
06: DC Bus Voltage (V)
07: PID Setpoint
08: PID Feedback (PV)
09: Frequency Setpoint
00
P8.01
Frequency Scale Factor 0.01 to 160.0 1.0
P8.02
Backlight Timer
00: Timer Enable (1 min light off)
01:Timer Disable
00
DURA
PULSE AC Drive User Manual 1st Ed. Rev. D 05/2013