AutomationDirect DURAPULSE GS3-2010, User Manual

Page: 65 / 316

3–17
Write Parameter Settings to Keypad
After P9.40 COPY KEYPAD is enabled, the LCD display will show an additional
group called COPY KEYPD GROUP. Press the PROGRAM key and then the
UP/DOWN or PROGRAM keys until this new group is displayed.
Press the ENTER key to display the copy mode selections.
Select the WRITE TO KEYPAD mode using the UP/DOWN keys.
Press the ENTER key to display the four (4) available program numbers to write
from the AC drive to the keypad. The program name will automatically be named
the part number of the AC drive, for example: GS3-22P0.
Use the UP/DOWN keys to select the desired program number; PGM1 thru
PGM4 and press the ENTER key.
Use the UP/DOWN keys to select “Yes” to confirm and press the ENTER key.
The LCD display will show the message “Drive => Keypad, Loading...” while the
parameters are being copied and return to the program selection when finished.
(Does not restore P9.40 back to Disable Copy Keypad Function.)
RAMPS GROUP
P 1.00-P 1.22
MOTOR GROUP
P 0.00-P 0.07
COMMS GROUP
P 9.00-P 9.42
ENC FBACK GROUP
P10.00-P10.05
PROGRAM PROGRAM
COPY KEYPD GROUP
(ENTER)
WRITE TO DRIVE
1
Select Parameter Group
WRITE TO KEYPAD
3 Select Copy Mode
ENTER ENTER
WRITE TO KEYPAD
PGM1: GS3-4040
WRITE TO KEYPAD
PGM2: GS3-22P0
ENTER ENTER
5 Select Program to Write
ENTER ENTER
6
Are you sure?
8
WRITE TO KEYPAD
PGM3: GS3-2025
WRITE TO KEYPAD
PGM4: - Empty -
2
4
NO
Are you sure?
YES
7 Confirm Selection
Drive => Keypad
L o a d i n g . . .
ENTER ENTER
9
The "=>" & "Loading..." display
text flashes during copy keypad.
ENT
FWD/REV
RESET
RUN
JOG
DISPLAY
PROGRAM
STOP
FWD JOG STOP RUN REV
Risk of electrical shock. Wait 10 minutes after removing power before
Do not connect AC power to output terminals T1,T2 and T3.
WARNING
servicing.
POWER
ALARM
W
ARNING
: Do not remove the Keypad during transfer of program parameter settings to
or from the AC drive.
Chapter 3: Keypad Operation and Quickstart
DURA
PULSE AC Drive User Manual 1st Ed. Rev. D 05/2013