AudioCodes MediaPack MP-40 series, User Manual

Page: 30 / 180

MediaPack BRI Series
User's Manual 30 Document #: LTRT-83702
3.3.3 Mounting the MediaPack on a Wall
The MediaPack is mounted on a wall by the addition of two short (equal-length) supplied
brackets. The MediaPack with brackets for wall mount is shown in
Figure 3-3 .
¾
To mount the MediaPack on a wall:
1. Remove the screw on the side of the device that is nearest the bottom and the front
panel.
2. Insert the peg on the bracket into the third air vent down on the column of air vents
nearest the front panel.
3. Swivel the bracket so that the side of the bracket is aligned with the base of the device
and the hole in the bracket line up with the empty screw hole.
4. Attach the bracket using one of the screws provided in the device package.
5. Repeat steps 1 to 4 to attach the second bracket to the other side of the device.
6. Position the device on the wall with the base of the device next to the wall.
7. Use four screws (not supplied) to attach the device to the wall.
Figure 3-3: MediaPack Wall Mounting
3.4 Cabling the MediaPack
This section describes the following MediaPack cabling procedures:
„
Connecting the LAN interface (refer to Section ' Connecting the LAN Interface ' on page
31 )
„
Connecting the WAN interface (refer to Section ' Connecting the WAN Interface ' on
page 31 )
„
Connecting the BRI S/T interface (refer to Section ' Connecting the ISDN BRI S/T
Interface ' on page 32 )