AudioCodes MediaPack MP-40 series, User Manual

Page: 120 / 180

MediaPack BRI Series
User's Manual 120 Document #: LTRT-83702
Table 6-17: WAN and LAN IP Settings Parameters
Parameter Description
[medium [10 full |10 half | 100
full | 100 half | auto]
Note: In the current version,
Media settings can only be
configured using CLI.
Defines the interface mode.
Valid options include:
ƒ
Auto = enables auto negotiation
ƒ
10T = interface configured for 10 Mbps Half duplex
ƒ
10TX = interface configured for 10 Mbps Full duplex
ƒ
100T = interface configured for 100 Mbps Half duplex
ƒ
100Tx = interface configured for 100 Mbps Full duplex
WAN Interface Parameters
Interface Mode
[ipmode]
Valid options include:
ƒ
DHCP (default)
ƒ
PPPoE
ƒ
Static
IP Address
[ipaddress <addr> <mask>]
Defines the interfaced IP address and subnet mask. This is only valid if the
interface mode is set to static.
Default WAN IP address: 192.168.2.1 (subnet mask: 255.255.255.0)
Subnet Mask Define the network mask of the IP address specified above.
Note: This parameter is only valid if the interface mode is set to Static.
ACL IN
[[no]acl-in]
Enables or disables the Access Control List for inbound traffic.
Valid options include:
ƒ
Enable
ƒ
Disable (default)
Note: In the current version, ACL can only be configured using CLI.
ACL OUT
[[no]acl-out]
Enables or disables the Access Control List for outbound traffic.
Valid options include:
ƒ
Enable
ƒ
Disable (default)
Note: In the current version, ACL can only be configured using CLI.
MTU
[mtu <value>]
Defines the Maximum Transfer Unit (MTU) of this IP interface. This value
specifies the size of the largest packet that can be sent over this interface in
one piece.
The default is 1,500.
If PPPoE is used, the actual MTU is reduced to the MTU determined during link
negotiation. In most cases, this is 1,492.
[medium [10 full |10 half | 100
full | 100 half | auto]
Note: In the current version,
Media settings can only be
configured using CLI.
Defines the interface working mode.
Valid options include:
ƒ
Auto = enables auto negotiation
ƒ
10T = interface configured for 10 Mbps Half duplex
ƒ
10TX = interface configured for 10 Mbps Full duplex
ƒ
100T = interface configured for 100 Mbps Half duplex
ƒ
100Tx = interface configured for 100 Mbps Full duplex