AudioCodes MediaPack MP-40 series, User Manual

Page: 68 / 180

MediaPack BRI Series
User's Manual 68 Document #: LTRT-83702
5.3 Embedded Command Line Interface
The MediaPack provides an embedded Command Line Interface (CLI) that can be used for
configuration and diagnostics. The CLI (or CommandShell) can be accessed using Telnet
or RS-232.
5.3.1 Logging into the CLI
You can access the MediaPack's CLI using a Telnet session or RS-232.
5.3.1.1 Embedded Telnet Server
¾
To access the CLI using the embedded Telnet server:
1. Use a standard Telnet application to connect to the MediaPack's Embedded Telnet
Server.
2. At the login prompt, type
Admin
, and then press Enter.
3. At the Password prompt, type
Admin
, and then press Enter.
Once successfully logged in (indicated by command prompt ‘>’), you are in Operator
Execution mode (for information on the CLI modes, refer to Section
'CLI Modes ' on page
68 ). The command prompt is preceded by the MediaPack's current LAN IP address, as
shown below:
'192.168.2.1>'
5.3.1.2 RS-232 Interface
¾
To access the CLI using the MediaPack's RS-232 interface:
1. Connect the RS-232 port to your PC (refer to ' Connecting the RS-232 Serial Interface'
on page 34 ).
2. Use a serial communication software (e.g., HyperTerminal
TM
) with the following
communications port settings:
•
Baud Rate: 115,200 bps (user-defined)
•
Data bits: 8
•
Parity: None
•
Stop bits: 1
•
Flow control: None
3. Login using username and password (the default is ‘Admin’ and ‘Admin’ respectively).
4. The baud rate may be changed using the CLI command “console baudrate
<baudrate>”. The valid rates to set are 9600, 19200, 38400, 57600 or 115200. The
default setting is 115200. The new baud rate will be effective after reset.