AudioCodes MediaPack MP-40 series, User Manual

Page: 97 / 180

User's Manual 6. Configuring the MediaPack
Version 2.2 97 July 2007
Table 6-6: ISDN Interface Parameters
Parameter Description
Digit Collection Timeout
[digit-collection timeout
<num>]
Specifies the digit collection timeout in seconds.
Valid range is 1 to 15 sec. Default value is 5 sec.
Digit collection
termination char
[[no]digit-collection
terminating-char <* | # | *#>]
Specifies a character that terminates digit collection.
Valid options include:
ƒ
* = indicates that the number is complete by pressing *
ƒ
# = indicates that the number is complete by pressing #
ƒ
*# = indicates that the number is complete by pressing * or #
ƒ
<empty> (default) = the user cannot indicate completion of the number
Digit collection Max No.
Len
[digit-collection nr-length
<num>
Specifies the maximum number length after which the number is assumed to be
complete.
Valid range is 1 to 30. The default value is 30.
Default Number
[[no]default-calling-party]
The phone number that is used in case the ISDN peer doesn't provide a CLIP. If no
phone number is defined, “anonymous” is used (default).
MSN
[[no]msn <number>]
Defines a phone number suffix for which all calls with the same suffix are accepted
when configured as a PMP user interface. Up to 8 phone number suffixes can be
defined. The maximum length of each number is 30.
Hunt Logic
[hunt-logic < cyclic-down |
cyclic-up | down | up>]
Determines the ISDN port allocation scheme by the ISDN interface for IP-to-ISDN
calls.
ƒ
Up = the highest available free port is used
ƒ
Down = the lowest available free port is used
ƒ
Cyclic-up (default) = the next higher free port is used
ƒ
Cyclic-down = The next lower free port is used
Add Port as Prefix
[no] add-port-as-prefix
If enabled, the ISDN port number of the incoming call is added to the source
number as the prefix.
Configuring ISDN Interface using CLI
To change the ISDN Interface parameters using CLI:
1. Log on to the system.
2. From the main configuration mode, change to the “context cs” mode.
3. Form the “context cs” mode, change to the “interface pstn” mode.
4. To enter the “interface pstn” mode, use the command:
interface pstn <0..3>
The last number indicates the interface number.
5. Use the commands in square brackets to change the parameters.